Usually before we apply the laser pipe cutting machine, we must type the corresponding cutting program flow in the computer. In other words, the first completed engineering drawings are typed into the computer, and the layout mobile phone software is used to typeset the drawings that must be cut, and then the cutting production and processing are carried out. The following is actually to know the common problems of the layout of the laser pipe cutting machine.
Parts spacing, generally in the case of cutting thicker plates or hot plates, it is necessary to increase the spacing between parts, because the heat of the thick steel plate is very large, in the case of cutting unique patterns or small patterns it is very easy to harm the cutting quality. Wire setting. In the process of cutting thick plates, in order to better make the cutting gap good and avoid burns.
There is often a connecting line at the beginning and end of the cutting. Only personalized connection, as far as possible to choose the arc appearance, which can promote the stable operation of the equipment, and lead to corner burns. Corner melting. When cutting arms at reduced rates, in the case of thick steel plates, the laser will cause Angle melting due to excessive temperature.
Residual material solution, when the cutting parts are carried out, the residual material on the table of the cutting machine equipment must be quickly removed to prevent the cutting work again. If the residual material is too large, the residual material can be cut into a small piece, which is convenient and rapid to move, and prevent the heavy residual material from moving and causing accidental injury.
Therefore, in the case of the use of laser pipe cutting machine to typeset, we must pay attention to a number of matters above, in order to improve the efficiency of the work.
English