Although the commodity characteristics of the laser cutting machine itself are very good, but in order to fully and smoothly show its effect, the working natural environment and other aspects of the equipment must meet its working conditions, so that the equipment can be stronger to carry out work, otherwise once it is in line with its working conditions in the area, it will not only harm the efficiency of the equipment. It will also cause damage to wear. So what are the working conditions of the device? Let's take a look.
Temperature: Laser cutting machine is generally all temperature control natural environment work, only under temperature control conditions, can ensure the normal operation of all equipment and equipment processing accuracy. The working temperature of the semiconductor material in the cutting machine is stipulated in the following 40~45 ° C, the internal temperature of the electrical control cabinet can reach 40 ° C when the indoor temperature is 35 ° C, and the equipment failure rate of the CNC machine tool will be increased when the indoor temperature is too high, so in order to better make the system software work well, the working temperature does not have to exceed 35 ° C.
Ambient humidity: The cutting machine stipulates that the air humidity in the natural environment is generally lower than 75%. Because the cutting machine in high temperature and low temperature is turned off after the power supply, the moisture in the air will cause condensate on the pcb board of the switching power supply or driver equipment, and the condensate water on the pcb board will cause short circuit fault when it is working again, which will cause common equipment faults.
Operating voltage: The voltage fluctuation of the power supply is very large, which will cause under-voltage protection or over-voltage alarm of the laser cutting machine, and even the loss of data information. Therefore, the operating voltage is generally specified within the range of ±10% of the rated operating value. In case of short circuit, it is recommended to configure an adjustable regulated power supply.
Anti-pollution: In the long-term laser cutting process, if there is no good ash removal, conductive smoke will harm the physical and mental health of the actual operation of the staff, in addition, if there is no good electric control cabinet, smoke into the electrical control cabinet and on the pcb circuit board or control module accumulation, will cause the destruction of electrical equipment components, especially high pressure components. Therefore, the equipment is required to be equipped with excellent ash removal equipment.
Grounding wire: All normal operation of the equipment must have an excellent grounding device. Sun exposure: to prevent the sun directly on the laser cutting machine immediately, the room should be equipped with excellent indoor lighting equipment. Natural ventilation: we mentioned the ambient humidity and conductive dust in the above working conditions, natural ventilation is a very natural way to remove, reasonable natural ventilation can be stronger to ensure the excellent operation of the cutting machine and the physical and mental health of the actual operation of the staff.
Therefore, in the case of the installation of laser cutting machine, it must be installed in an area that is in line with this working conditions, so that it can be stronger to prevent the impact of some environmental factors and other external factors, so that the cutting machine equipment can work very well.
English