Laser cutting machine has a good cutting effect. Compared with traditional processing and cutting, it has obvious processing advantages, saving time, manpower, efficiency and high precision. With the application of metal laser cutting machines more and more widely, they will be used in sheet metal processing, aviation, electronics, electrical appliances, kitchenware and other industries. Here is how to use a laser cutting machine to achieve good results.
The cooling system should be grounded, and the water tank and waterway should be cleaned frequently, otherwise the laser tube will be damaged, the condensing power will be reduced, the cold head of the tube will fall off, the life of the tube will be greatly shortened, and sometimes it will not work, resulting in continuous tube replacement. Laser cutting machine laser tube installation fulcrum should be reasonable. The fulcrum should be 1/4 of the total length of the laser tube. Otherwise, the laser spot pattern of the laser tube will deteriorate. In some cases, the laser spot will become several points after working for a period of time, which will cause the laser power to decrease and cannot meet the requirements, resulting in continuous tube replacement.
Water protection should be checked and cleaned frequently. The water protection float switch cannot be washed with cooling water or the water protection float switch cannot be reset. The short-circuit method cannot be used to solve urgent problems. Should regularly check and clean the suction device, clean the fan pipe, otherwise it will produce a lot of smoke, pollute the lens and laser tube, make the mechanical and electronic components easy to oxidize, resulting in poor contact.
Focal length lens and reflector inspection: After working for a period of time, the frame will heat up, the lens surface will discolor and rust; Peeling and cracking of the film are phenomena that need to be replaced, especially when customers use large air pumps and air compressors, water will quickly accumulate on the focusing lens, so it is necessary to check the cleanliness and quality of the lens optical system in time.
The working environment of laser cutting machine should not be too bad. If the ambient temperature is higher than 30 degrees, lower than 18 degrees, there is too much dust, air pollution is serious, the machine will be seriously damaged, the failure rate will continue to rise; Electrical accessories often have problems in humid environments.
English